When was the last time you cleaned your bathroom faucets?
While cleaning and maintaining your bathroom faucets might not be at the top of your to-do list, it should be. Like other fixtures in your home, regular maintenance and cleaning will save you money on your water bill.
In fact, a leaking faucet can waste up to 465 gallons of water in a single year!
This article will help you understand how to fix a dripping bathtub faucet. Keep reading to learn about it and how to get the fixtures repaired.
Fast Ways on How to Fix a Dripping Bathtub Faucet
First, you want to make sure that the O-ring is not damaged and that it is seated in the valve seat. Next, tighten the packing nut. If that doesn’t work, you may need to replace the washer.
Finally, if none of those things work, you may need to replace the entire tap.
Off the Water and Remove the Handle
Before you attempt to do a dripping bathtub faucet repair, you need to shut off the water to the spout. To do this, you will need to locate the main water shut-off valve for your home and turn it to the “off” position. Once the water is shut off, you can proceed with repairing the faucet.
Next is to remove the handle of the tap to access the washer. This will allow you to inspect the washer and see if it needs to be replaced.
Tighten the Washer and Replace the O-Ring
Tighten the washer until it is snug. This may stop the drip. If the drip continues, you may need to replace the washer.
To do this, turn off the water on the tap and remove the handle. The washer is usually under the handle.
One option is to replace the O-ring. This is a small rubber ring that goes around the valve stem. Over time, it can become worn out and cause the faucet to leak. You can buy an O-ring at most hardware stores.
Tighten the Packing Nut
Remove the handle to access the packing nut. Use a wrench to tighten it. Be sure not to over-tighten, as this can damage the faucet.
Call a Plumber for Help
This page will give you a few things you can try before calling a plumber for help. First, check to see if the problem is with the hot or cold water side by turning on the opposite tap to see if it is dripping. If so, the issue is likely with your home’s water pressure and you will need to adjust the pressure regulator.
You will need to call a plumber if this does not solve the bathtub faucet problems.
End the Annoyance of Dripping Faucet
The first thing you should do if you don’t know how to fix a dripping bathtub faucet is to check the washer. If it is loose or worn out, if the problem is not with the washer, it may be with the O-ring. The O-ring helps to seal the connection between the valve and the faucet.
If you cannot find the source of the problem, you may need to call a plumber. With these tips, you should be able to fix a dripping faucet.
Did you learn something from this article? Kindly read our other blogs!
